EO Flash-PLK was specifically designed to replace the memory Prom cartridge used in programmable sewing machines Mitsubishi® PLK with significant advantages in terms of designs capacity and lightness of use.
The dimensions of the Flash-PLK device are nearly similar to the normal Mitsubishi PLK memory cartridges and it is installed in the same machine slot. The device is written using a Windows® application called EO Flash-PLK Writer that runs perfectly in a common PC computer.
This application reads designs stored in all the popular comercial embroidery codes and send them to the device using a standard serial port through a cable supplied with EO Flash-PLK Writer license.
Once written and inserted in the memory cartridge slot, the device gets power and sends information to the machine through it.
Flash-PLK devices can store up to 64 designs in normal mode and up to 640 designs in extended mode, easily selectable using a pair of numeric switches and the normal numeric switch built in the machine.
To ensure the proper identification of designs stored in the device, EO Flash-PLK Writer allows printing of resume sheets with the designs and their corresponding switches combination.
EO Flash-PLK devices stores the information in a high density EEPROM FLASH memory that do not require any power to hold it, avoiding data losses due to battery exhaustion or accidental connections with the device power on.
Capacity
The bulit-in memory capacity of EO Flash-PLK is equivalent to 64 original prom memory of 4000 stitches, totalizing a maximun capacity of 256000 stitches. The device memory is organize in 64 folders or partitions. Each partition can hold up to 10 designs or up to a total of 4000 stitches, allowing a maximun of 640 designs.
Installation
EO Flash-PLK device is simply installed in the machine slot intended to the memory prom cartridge.
Designs Selection and Execution
Design selection is acomplished using a pair of numeric switches located in the device front panel. After performing a machine reset cycle, the selected design is available for execution.
Utilities & Accesories
EO Flash-PLK was specifically designed to replace the memory Prom cartridge used in programmable sewing machines Mitsubishi® PLK with significant advantages in terms of designs capacity and lightness of use. 
This application reads designs stored in all the popular comercial embroidery codes and send them to the device using a standard serial port through a cable supplied with EO Flash-PLK Writer license.
Flash-PLK devices can store up to 64 designs in normal mode and up to 640 designs in extended mode, easily selectable using a pair of numeric switches and the normal numeric switch built in the machine.